Omnitracs MCP100, Руководство по установке

Страница: 49 / 256

80-J4866-2 Rev. G
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
4-7
Installation Planning Straight Truck Vehicle Types (All Makes)
Mack
• MAS — Install on side wall or hang under the bunk.
- Install so there is always SD card slot access.
• MDU — Install on face of connector panel.
• Cables — Route externally.
- Drill a 1-1/2" hole in floor of side box for SDM cable.
Straight Truck Vehicle Types (All Makes)
• MAS — Install on side wall or hang under bunk.
- Install so there is always SD card slot access.
• MDU — Install where space allows/customer preference.
• Cables — Route externally or internally.
- Tilt cabs may require longer cables.
- Drill a 1-1/2" hole in floor of side box for SDM cable.
Cabover Engine Vehicle Types (All Makes)
• MAS — Install on side wall or hang under bunk.
- Install so there is always SD card slot access.
• MDU — Install on dash.
• Cables — Route internally.
- Connect power cable to main bus or keyswitch.
- Drill a 1-1/2" hole in floor of side box for SDM cable.
Special Cable Ordering Instructions for Tilt Cabs
• Typically, the SDM cable must be routed through the cab
pivot point to allow for the tilt.
• In most tilt cab vehicles, this routing requires a longer
cable than the standard cable.
• When ordering the MCP100, specify the length of the
cable(s) you need.
Display
Power-
Main
Power Bus
Antenna cable
access hole
MAS
Mack
Straight Trucks
Fixed Cab
Fixed Cab + Sleeper
Outdoor
Unit
Outdoor
Unit
Display
Unit
Display
Unit
MAS
Power Bus/
Key Switch
Power Bus/
Key Switch
MAS
MAS
Antenna cable
access hole
Display
Electrical
Panel
Cabover Engine
Tilt Cab
Pivot Point
Display
Unit
Power Bus/
Key
Switch
MAS
Longer
Cable
Outdoor
Unit
Tilt Cab