OmniSwitch os6900, Руководство по настройке сети, Страница: 832 / 942

Switch Health Overview Diagnosing Switch Problems
page 32-14 OmniSwitch AOS Release 7 Network Configuration Guide June 2013
Switch Health Defaults
The following table shows Switch Health default values.
Global Switch Health Defaults
Quick Steps for Configuring Switch Health
1
Display the health threshold limits, health sampling interval settings, and/or health statistics for the
switch, depending on the parameters you wish to modify. (For best results, note the default settings for
future reference.) For example:
-> show health configuration
The default settings for the command you entered is displayed. For example:
Rx Threshold = 80
TxRx Threshold = 80
Memory Threshold = 80
CPU Threshold = 80
Sampling Interval (Secs) = 10
2
Enter the appropriate command to change the required health threshold or health sampling interval
parameter settings or reset all health statistics for the switch. For example:
-> health threshold memory 85
Note. Optional. To verify the Switch Health configuration, enter show health configuration , followed by
the parameter you modified (like the memory percent ). The display is similar to the one shown below:
Memory Threshold = 85
For more information about this command, see “Displaying Health Threshold Limits” on page 32-44 or
the “Health Monitoring Commands” chapter in the OmniSwitch CLI Reference Guide.
Parameter Description CLI Command Default Value/Comments
Resource Threshold Limit Configuration health threshold 80 percent
Sampling Interval Configuration health interval 5 seconds
Switch Temperature health threshold 60 degrees Celsius