OmniSwitch os6900, Руководство по настройке сети, Страница: 696 / 942

Modifying Policy Servers Managing Policy Servers
page 26-4 OmniSwitch AOS Release 7 Network Configuration Guide June 2013
Modifying Policy Servers
Policy servers are automatically configured when the server is installed; however, policy server
parameters can be modified if necessary.
Note. SSL configuration must be done manually through the policy server command.
Modifying LDAP Policy Server Parameters
Use the policy server command to modify parameters for an LDAP policy server.
Keywords for the command are listed here:
For information about policy server parameter defaults, see “Policy Server Defaults” on page 26-2 .
Disabling the Policy Server From Downloading Policies
Policy servers can be prevented from downloading policies to the switch. By default, policy servers are
enabled to download policies.
To disable a server, use the policy server command with the admin-state keyword and disable option.
-> policy server 10.10.2.3 admin-state disable
In this example, an LDAP server with an IP address of 10.10.2.3 is not used to download policies. Any
policies already downloaded to the switch are not affected by disabling the server.
To re-enable the server, specify enable .
-> policy server 10.10.2.3 admin-state enable
The server is now available for downloading policies.
To delete a policy server from the configuration, use the no form of the command with the relevant IP
address:
-> no policy server 10.10.2.3
If the policy server is not created on the default port, the no form of the command must include the port
number. For example:
-> no policy server 10.10.2.4 5000
Policy server keywords
port
admin
preference
user password
searchbase
ssl