OmniSwitch os6900, Руководство по настройке сети, Страница: 605 / 942

Configuring IP Multicast Switching IPMSv6 Application Example
OmniSwitch AOS Release 7 Network Configuration Guide June 2013 page 24-39
IPMSv6 Application Example
The figure below shows a sample network with the switch sending multicast video. A client attached to
Port 5 needs to be configured as a static MLD neighbor and another client attached to Port 2 needs to be
configured as a static MLD querier.
Example of IMPS Network
The network administrator has determined that the network is too lossy and therefore the robustness vari-
able needs to be set to a higher (i.e., 7) value.
Follow the steps below to configure this network:
Note. All the steps following Step 1 (which must be executed first) can be entered in any order.
1
Enable IP Multicast Switching and Routing switch-wide, by entering:
-> ipv6 multicast admin-state enable
2
Configure the client attached to Port 5 as a static MLD neighbor belonging to VLAN 5 by entering:
-> ipv6 multicast static-neighbor vlan 5 port 1/5
3
Configure the client attached to Port 2 as a static MLD querier belonging to VLAN 5 by entering:
-> ipv6 multicast static-querier vlan 5 port 1/2
4
Modify the robustness variable from its default value of 2 to 7 by entering:
-> ipv6 multicast robustness 7
OmniSwitch
Multicast Server
(source IPv6 address)
Static Neighbor
Attached to Slot 1, Port 5.
Static Querier
Attached to Slot 1, Port 2.
Video
Network Clients
Network clients send MLD
requests to receive multicast
traffic.