OmniSwitch os6900, Руководство по настройке сети, Страница: 452 / 942

RIP Routing Configuring RIP
page 19-8 OmniSwitch AOS Release 7 Network Configuration Guide June 2013
•
v2. Only RIPv2 packets is sent by the switch.
•
v1compatible. Only RIPv2 broadcast packets (not multicast) is sent by the switch.
•
none. Interface does not forward RIP packets.
To set the default RIP send option use the ip rip interface send-version command.
Use the show ip rip interface command to display the current interface send option.
Configuring the RIP Interface Receive Option
The RIP Receive option defines the type(s) of RIP packets that the interface accepts. Using this command
overrides RIP default behavior. Other devices must be able to interpret the information provided by this
command or routing information is not properly exchanged between the switch and other devices on the
network.
Use the ip rip interface recv-version command to configure an individual RIP interface Receive option.
Enter the IP address of the RIP interface, and then enter a Receive option. For example, to configure RIP
interface rip-1 to receive only RIPv1 packets you would enter:
-> ip rip interface rip-1 recv-version v1
The Receive options are:
•
v1. Only RIPv1 packets is received by the switch.
•
v2. Only RIPv2 packets is received by the switch.
•
both. Both RIPv1 and RIPv2 packets is received by the switch.
•
none. Interface ignores any RIP packets received.
To set the default RIP receive option use the ip rip interface recv-version command.
Configuring the RIP Interface Metric
You can set priorities for routes generated by a switch by assigning a metric value to routes generated by
that switch’s RIP interface. For example, routes generated by a neighboring switch can have a hop count
of 1. However, you can lower the priority of routes generated by that switch by increasing the metric value
for routes generated by the RIP interface.
Note. When you configure a metric for a RIP interface, this metric cost is added to the metric of the
incoming route.
Use the ip rip interface metric command to configure the RIP metric or cost for routes generated by a
RIP interface. Enter the IP address of the RIP interface as well as a metric value. For example, to set a
metric value of 2 for the RIP interface rip-1 you would enter:
-> ip rip interface rip-1 metric 2
The valid metric range is 1 to 15 . To change the default value use the ip rip interface metric command.
Use the show ip rip interface command to display the current interface metric.