OmniCell OmniTT, Инструкция по установке и обслуживанию

Страница: 6 / 41

1-2 Electronics Tray
Removal Procedure
OmniTT/AnesthesiaTT Installation and Service Guide/67-2024 Rev D © 2010 Omnicell, Inc.
LCD Assembly
1. Tilt the LCD assembly forward and disconnect the cables from the back of the LCD assembly.
a. Disconnect the inverter to power cable .
b. Disconnect the flat panel cable .
2. Set the lid back down.
3. Remove the four inner screws at the back of the console lid.
Figure 1-2. Remove the Four Inner Screws
4. Remove the LCD assembly from the LCD housing.
Speaker
1. Perform a graceful shutdown of the electronics tray.
2. Open the console top.
3. Remove the speaker from the motherboard.
Figure 1-3. Disconnect the speaker From the motherboard
Note:
Hold onto the front of the LCD screen while removing the screws so that the assembly does not fall.