7
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Figure 6
Figure 7
WARNING: THE SIZE AND POSITION ON
THE LOG SET WAS ENGINEERED TO GIVE
YOUR APPLIANCE A SAFE, RELIABLE AND
ATTRACTIVE FLAME PATTERN. ANY AT-
TEMPT TO USE A DIFFERENT LOG SET IN
THE FIREPLACE WILL VOID THE WAR-
RANTY AND WILL RESULT IN INCOM-
PLETE COMBUSTION, SOOTING, AND
POOR FLAME QUALITY.
WARNING: LOGS GET VERY HOT AND
WILL REMAIN HOT UP TO ONE HOUR
AFTER GAS SUPPLY IS TURNED OFF.
HANDLE ONLY WHEN LOGS ARE COOL.
TURN OFF ALL ELECTRICITY TO THE
APPLIANCE BEFORE YOU INSTALL
GRATE AND LOGS.
WARNING: THIS APPLIANCE IS NOT
MEANT TO BURN WOOD. ANY ATTEMPT
TO DO SO COULD CAUSE IRREPARABLE
DAMAGE TO YOUR APPLIANCE AND
PROVE HAZARDOUS TO YOUR SAFETY.
Log Placement
Carefully position the ceramic fiber logs and
twigs over the burner as shown in
Figure 5.
For
more detailed log placement instructions, see
those provided in the LOG PLACEMENT GUIDE
accompanying this document.
Proper twig placement is critical to prevent
sooting. Twigs should be placed in the gaps
between the flame peaks and should be posi-
tioned so that at no time they impinge the flames.
Glowing Embers (Rockwool) Placement
Remove the replacement rockwool from the
packaging and tear into nickel size pieces
(
Figure 6
). Spread along the front edge of the
front burner over the screen assembly. Do not
use more than is necessary.
When properly positioned, the rockwool will
unevenly cover approximately 85% of the gap
between the front burner and the burner screen
with no appreciable openings.
For more detailed glowing ember place-
ment instructions, see those provided in
the LOG PLACEMENT GUIDE accompany-
ing this document.
Decorative Volcanic Stone Placement
(See Figure 6 )
Spread this Decorative Volcanic Stone evenly
over the bottom surface of the appliance fire-
box bottom plate as desired to achieve an
esthetically pleasing appearance. For best re-
sults, spread in a non-uniform manner while
ensuring complete coverage of the black sheet-
metal surface.
Note:
Do Not place decorative volcanic stone
on top of the gas burner where it will block the
burner ports.
SIT and Honeywell Millivolt Appliance Checkout
The pilot flame should be steady, not lifting or
floating. Flame should be blue in color with
traces of orange at the outer edge.
The top
³⁄₈
" (10 mm) at the pilot generator (ther-
mopile) and the top
¹⁄₈
" min (tip) of the quick drop
out thermocouple should be engulfed in the pilot
flame. The flame should project 1" (25 mm)
beyond the hood at all three ports (
Figure 9 - SIT,
Figure 10 - Honeywell
).
To light the burner, refer to the lighting instruc-
tions on
pages 11 and 12
for Honeywell and SIT
millivolt gas valves).
Figure 9
Figure 8
¹⁄₈
" Min
(3 mm)
Thermocouple
Ignitor Rod
Hood
³⁄₈
" Min
(9 mm)
Thermopile
MILLIVOLT HONEYWELL
Pilot
Nozzels
SIT MILLIVOLT
Thermocouple
Hood
Ignitor Rod
³⁄₈
" Min
(9 mm)
Thermopile
Pilot
Nozzels
