Omicron CMC 356, Руководство пользователя

Страница: 17 / 142

Operating the CMC 356
17
3.4 Starting the Test System
The following description assumes that the computer has been set up and
that the test software for the OMICRON
Test Universe has been installed.
Detailed instructions for installing the software for the OMICRON Test
Universe can be found in the software manual "The Concept".
This description refers both to the computer and to the CMC 356 . It does not
take into consideration any external devices. If the system is driven by
external amplifiers, follow the instructions in section 7.5, "Operation with
External Amplifiers" on page 99.
When setting up the CMC 356 , it is most important to make sure that the
ventilation slots remain unobstructed.
Connecting the System Components:
Figure 3-1:
Connecting the
CMC 356
to the computer
1. Connect the CMC 356 to the PC with the supplied connecting cable
1
:
• CMC 356 : Connector ETH1 at the rear sinde of the test set
• PC: Ethernet port (labeled “EtherNET”, “LAN” or similar).
For instructions to help you to incorporate network-capable CMC test
sets, such as the
CMC 356 into a computer network, please refer to
the manual "Network-based CMC Test Sets". This manual is provided
in PDF format; its name is
Network-based test sets.pdf . It is
available on your hard disk at
Test Universe installation folder \Test Universe\Doc \.
1
To ensure the required EMC compatibility, we recommended to only use the OMICRON-
supplied connecting cable.
OMICRON-supplied connecting cable