52
SPECTANO 100 User Manual
Table 10-8
Result view controls (continued)
Control
Description
Cursor table
Impedance calculation
4
Parallel circuit
Select the parallel equivalent circuit as dielectric
model.
Serial circuit
Select the serial equivalent circuit as dielectric
model.
x-Axis
5
Xmax
Select the maximum value of the right x-axis.
Xmin
Select the minimum value of the right x-axis.
1.
Only available for material measurements
2.
Only available for the PDC and combined measurement modes selected in the sweep settings under
Measurement type
.
3.
Specific resistance and conductivity are only available for DSH 100 and Disk electrode test cell selection.
4.
The impedance calculation affects only the numerical measurement results Rp/Rs und Cp/Cs displayed in the table but not
the Bode diagram of R and X.
5.
Only seen in the
Chart result view
PDC: Ipol and Idepol and the three Cole-Cole chart views.
Note:
Some result view controls are not available for all chart result views.
