7.3.5 Log & Notification page
Select the corresponding pane to specify your settings for the logging of system messages and the
event notification. Click the
Save
button to save and apply your log & notification settings specified in
the individual tabs to
OTMC 100
.
7.3.5.1
Log pane
Level
Use this list box to select the level as of which you want to have system
messages logged to the selected target. Lower levels include the messages
of higher levels.
The following levels are available (starting from the lowest level):
Debug
,
Info
,
Warning
,
Error
,
Critical
.
Target
Use this list box to select the target where you want to have the system
messages logged to:
Local logfile only
: Logging is performed to the internal log file that can be
Status
section.
Local log and IPv4 syslog server
and
Local log and IPv6 syslog server
:
Logging is performed to the internal log file and to the specified syslog
server for IPv4 or IPv6 installed in the network.
Remote host &
Remote port
Use this field to specify the hostname and port number of the syslog server
in the network used as log target for the system messages.
Only active if the
Target
list box is set to
Local log and IPv4/IPv6 syslog
server
.
Remote transport
Use this field to specify the network transport protocol of the IPv4 or IPv6
syslog server, if selected in the
Target
field.
Select
UDP
(User Datagram Protocol) or
TCP
(Transmission Control
Protocol).
Enabled sources
Select the corresponding check box to enable logging for a particular
message type (for example, GPS messages, PTP messages etc.).
OTMC 100 Series User Manual
72
OMICRON
Содержание OTMC 100
Страница 1: ...Smart Measurement Solutions OTMC 100 User Manual...
Страница 89: ...ENU 1066 05 01...