3
Introduction
1
INTRODUCTION
The Platinum
™
Series Universal Benchtop Digital Controller, is ideal for laboratory and other applications
requiring portable, temperature, process or strain, measurement and control. It features a universal
input which reads most temperature, process and bridge type inputs. The Benchtop Digital Controller
has excellent accuracy and is factory calibrated to give optimum performance over its full operating
range.
1.1
Safety and Precautions
It is important to read and follow all precautions and instructions in this manual and other referenced
manuals, before operating or commissioning this device, as it contains important information relating to
safety and EMC.
•
Do not exceed the voltage rating.
•
Always disconnect the power before changing the signal and power connections.
•
Do not operate in flammable or explosive environments.
•
Never operate with a power cord that is not properly rated for use with this unit.
•
Remove and or disconnect main power cord before attempting any maintenance or fuse
replacement.
•
Do not connect and/or operate this unit to a non-grounded or non-polarized outlet or power
source.
There are no user serviceable parts inside the unit. Attempting to repair or service
the unit may void the warranty.
This product is not designed for medical applications.
1.2
Cautions and IEC Symbols
This device is marked with international safety and hazard symbols shown in the table below, in
accordance with 2014/35/EU Low Voltage Directive. It is important to read and follow all precautions
and instructions in this manual before operating or commissioning this device as it contains important
information relating to safety and EMC. Failure to follow all safety precautions may result in injury
and/or damage to the controller. Use of this device in a manner not specified by the manufacturer may
impair protection devices and safety features provided by the unit.
IEC Symbol
Description
CAUTION
, risk of electrical shock
CAUTION
, refer to accompanying documents
1.3
Statement on CE Marking
OMEGA
’s
policy is to comply with all worldwide safety and EMI/EMC regulations that apply to CE
Certification standards, including
EMC Directive
2014/30/EU Low Voltage Directive (Safety) Directive
2014/35/EU, and
EEE RoHS II Directive
2011/65/EU. OMEGA is constantly pursuing certification of its
products to the European New Approach Directives. OMEGA will add the marking to every applicable
device upon verification of compliance.
1.4
Available Models
Model
Features
CS8DPT-C24-EIP-A
Benchtop Controller with 4-Digit Display, Embedded Ethernet,
Serial Communication, and Isolated Analog Output
-EIP
Ethernet
-C24
Isolated RS232 and RS485
-A
Isolated Analog Output
CS8DPT
Benchtop Controller, Universal input with 4-Digit Display
CS8EPT
Benchtop Controller, Universal input with 6-Digit Display
CS8EPT-C24-EIP-A
Benchtop Controller with 6-Digit Display, Embedded Ethernet,
Serial Communication, and Isolated Analog Output