![background image](http://html1.mh-extra.com/html/omega/owc15/owc15_instruction-manual_4057463005.webp)
2
INSTALLATION INSTRUCTIONS
Before using your wine cooler:
Remove the exterior and interior packing.
Before connecting the wine cooler to the power source, let it stand upright for approximately 24 hours. This will reduce the
possibility of a malfunction in the cooling system from handling during transportation.
Clean the interior surface with lukewarm water with a soft cloth.
Installation of wine cooler:
This appliance is designed to be for free standing installation and should not be built-in.
Place your wine cooler on a floor that is strong enough to support it when it is fully loaded.
To level your wine cooler, adjust the feet positions. Leave a gap of at least 10cm to the sides and rear of the appliance to allow
for ventilation.
Locate the wine cooler away from direct sunlight and sources of heat (stove, radiator, electric radiator, etc.). Direct sunlight may
affect the acrylic coating and heat sources may increase electrical consumption. Avoid locating the unit in moist area.
Plug the wine cooler into an exclusive, properly installed-grounded wall outlet. Do not remove the ground wire from this
appliance.
This wine cooler is not designed for use with an inverter.
Allow the wine cooler to run and cool down for at least 4 hours before adding the wine.
This appliance is not intended to be operated by means of an external timer or a separate remote-control system. Do not use
extension power cords with this device (the use of which can negatively affect the performance of the wine cooler). Secure the
power cord behind the wine cooler and do not leave exposed where it can be a tripping hazard.
Note that on first use there might be a slight smell which is due to the manufacturing process. This should dissipate after a few
hours.
Controls
1. Light Control Button
2. C°/F° Select Button
3. LED Display
4. Temp Increase Button
5. Temp Reduce Button
•
To turn the interior light on and off, press the light control button (1).
•
Adjust the temperature display to show Celsius or Fahrenheit by pressing the C°/F° select button (2). This will be
indicated with the icons to the right of the LED display.
•
Adjust the internal temperature setting by pressing the Temp increase button (4) and Temp decrease button (5). Each
press will adjust by 1 degree. The factory pre-set is 12°C/54°F.
•
The LED display (3) will indicate the current internal temperature. When a temperature adjustment is made, the new
temperature will be shown for a few seconds and then the display will revert back to the internal temperature.
•
On first use, the compressor will run continuously while the wine cooler cools down. It is best not to open the door while
this is taking place.
•
If the wine cooler is unplugged, allow it to sit for 3-5 minutes before plugging it back in. Attempting to restart the wine
cooler too early may cause the compressor not to start.
Содержание OWC15
Страница 1: ...INSTRUCTION MANUAL FOR OMEGA WINE COOLER OWC15 ...
Страница 2: ......