Omega OUM52X, Инструкция по эксплуатации

Страница: 9 / 13

9
Maintenance and Cleaning
Safety Precaution
• Before cleaning your rangehood or performing any maintenance, please ensure that the range hood
is turned off at the power point.
• External surfaces are susceptible to scratches and abrasions, so please follow the cleaning
instructions to ensure the best possible result is achieved without damage.
• Cleaning and maintenance should be carried out with the appliance cold especially when cleaning.
Avoid leaving alkaline or acid substances (lemon juice, vinegar etc.) on the surfaces.
• The stainless steel must be cleaned regularly (e.g. Weekly) to ensure a long life expectancy. Dry
with a clean soft cloth. A specialized stainless steel cleaning fluid may be used.
• Ensure that wiping is done along with the grain of the stainless steel to prevent any unsightly
crisscross scratching patterns from appearing.
• The inlay control panel can be cleaned using warm soapy water. Ensure the cloth is clean and well
wrung before cleaning. Use a dry soft cloth to remove any excess moisture left after cleaning.
Important
Using neutral detergents and avoid using harsh cleaning chemicals, strong household detergents or
products containing abrasives, as this will affect the appearance of the appliance and potentially remove
any printing of artwork on the control panel and will void manufactures warrantee.
GREASE MESH FILTERS
The mesh filters are dishwasher safe and can also be hand washed.. Soak them for about 3 minutes in
water with a mild detergent and then brush them gently with a soft brush. Do not apply too much pressure
so as to avoid any damage to it. (Leave to dry naturally out of direct sun light)
Filters should be washed separately to crockery and kitchen utensils. It is advisable not to use rinse aid.
INSTALLING GREASE MESH FILTERS
• To install filters for the following four steps:
• Angle the filter into the slots at the back of the hood.
• Push the button on the handle of the filter.
• Release the handle once the filter fits into a resting position.
• Repeat to install all filters.