![background image](http://html1.mh-extra.com/html/omega/cn16pt/cn16pt_user-manual_4067472054.webp)
PLATINUM
TM
Series User’s Guide
54
Reference Section: Operating Mode (oPER)
Return to
RUN
Mode or to displaying “
RUN
” depending on the Operating Safety parameter
setting (
4.5.2 Operating Mode Confirmation (INIt > SFty > oPER)
).
6.6
Stop Process (oPER > StoP)
Select the Stop Operating Mode (
StoP
) to turn off all control outputs. The current process
value remains with flashing digits in this mode. Alarm conditions are maintained.
Return to
RUN
Mode or to displaying “
RUN
” depending on the Operating Safety parameter
setting (
4.5.2 Operating Mode Confirmation (INIt > SFty > oPER)
).
6.7
Clear Latched Alarms (oPER > L.RSt)
Select the Clear Latched Alarms command (
L.RSt
) to clear currently latched Alarms.
Alternatively, use digital input to activate the
L.RSt
command if configured in the PRoG menu
as explained in
5.3.4 Alarm Latching (PRoG > ALM.1, ALM.2 > LtCH)
Return to
RUN
Mode or to displaying “
RUN
” depending on the Operating Safety parameter
setting (
4.5.2 Operating Mode Confirmation (INIt > SFty > oPER)
).
6.8
Display Valley Reading (oPER > VALy)
Select Display Valley Reading (
VALy
) to change the process value displayed to the lowest
reading since
VALy
was last cleared.
Clear the
VALy
reading buffer. Return to
RUN
Mode or to displaying “
RUN
” depending on the
Operating Safety parameter setting (
4.5.2 Operating Mode Confirmation (INIt > SFty > oPER)
).
Note:
Using the other buttons to navigate away from
VALy
does not clear the
VALy
reading
buffer.
6.9
Display Peak Reading (oPER > PEAk)
Select Display Peak Reading (
PEAk
) to change the process value displayed to the highest
reading since
PEAk
was last cleared.
Clear the
PEAk
reading buffer. Return to
RUN
Mode or to displaying “
RUN
” depending on the
Operating Safety parameter setting (
4.5.2 Operating Mode Confirmation (INIt > SFty > oPER)
).
Note:
Using the other buttons to navigate away from
PEAk
does not clear the
PEAk
reading
buffer.
6.10
Standby Mode (oPER > Stby)
Select Standby Mode (
Stby
) to disable outputs and Alarm conditions.
Stby
is displayed until
navigating elsewhere. Navigate to any desired initialization or programming settings to
change them or to adjust the process.
Return to
RUN
Mode or to displaying “
RUN
” depending on the Operating Safety parameter
setting (
4.5.2 Operating Mode Confirmation (INIt > SFty > oPER)
).
Omega Engineering | www.omega.com
Содержание CN16Pt
Страница 1: ...CN32Pt CN16Pt CN16PtD CN8Pt CN8PtD Temperature Process Controllers...
Страница 60: ...Omega Engineering www omega com...
Страница 61: ...M5451 0415 Omega Engineering www omega com...