SPECIFICATIONS
Model
Capacity
Jack Size (L x W x H)
Min. Height Max. Height Saddle Dia. Volume of Hyd. Oil
25037
3 Ton
31-7/8" x 15-3/8" x 7-3/8"
4"
23"
5 - 1/2"
330 mL
3
To avoid crushing and related injuries:
•
Never work on, under or around a load supported
only by hydraulic jack.
•
Always use adequately rated jack stands.
• Chock each unlifted tire in both directions.
• Do not use this device to lift, level, lower, support
nor move a house, mobile home, travel trailer,
camper or any building structure.
• Be alert and sober when using this product.
Do not operate under the influence of drugs or
alcohol.
!
WARNING
X
!
WARNING
• Study, understand, and follow all instructions
before operating this device.
• Do not exceed rated capacity.
• Use only on hard, level surface.
• Lifting device only. Immediately after lifting,
support the vehicle with appropriate means.
• Lift only on areas of the vehicle as specified by
the vehicle manufacturer.
• Do not move or dolly the vehicle while on the
jack.
• No alterations shall be made to this product.
• Failure to heed these markings may result in
personal injury and/or property damage.
7. Ensure that jack rolls freely. Raise and lower the unloaded saddle throughout the entire lifting range before
putting into service to ensure the pump operates smoothly. Replace worn or damaged parts and assemblies with
authorized replacement parts only.
Bleeding/Venting Trapped Air
With the release valve in the OPEN position (step 5b. above) and with saddle fully lowered, locate and remove the
oil filler plug. Pump handle 6 to 8 full strokes. This will help release pressurized air which may be trapped within the
reservoir. Reinstall the oil filler plug and check operation.
OPERATION
Lifting
1. Follow the vehicle manufacturer’s recommended guidelines for lifting. Engage the emergency brake and chock
each unlifted wheel in both directions to prevent inadvertent vehicle movement.
2. Close the release valve by turning the handle clockwise until firm resistance is felt.
3. Refer to the vehicle manufacturer owner’s manual to locate approved lifting points on the vehicle. Center jack
saddle under lift point.
4. Verify lift point, pump handle until saddle contacts lift point. To lift, pump handle until load reaches desired height.
5. Transfer the load to appropriately rated jack stands.
Lowering
WARNING:
Clear all tools and personnel before lowering vehicle. Open release valve slowly.The further
the pump handle is turned counter-clockwise, the faster the load will descend.Maintain control of load at all
times.
!
