Omcan B34, Инструкция по эксплуатации

Страница: 7 / 24

7
Operation
Maintenance
regulator (optional), maintaining the thickness of the slice desired.
When pulling back the product do not touch the blade avoiding disconnecting it from the wheels.
Drop a little bit of water onto the fixed table to facilitate the slipping of the product.
COMPONENTS ADJUSTMENT
PULLEY BELT
• The belt must be firmly fixed to prevent it from skidding. Do not tighten it too much because it can wear out
quickly.
• To have access to the belt remove the screws with a screwdriver from the inferior back lid and take it out.
• With a screw-wrench loosen the screws turning it counter-clockwise. To stretch out the belt you have to
push the motor with the wood lever tightening the screws.
IMPORTANT: The pulleys must be lined up.
UPPER BEARING ADJUSTMENTS
• The purpose of this adjustment is to centralize the blade on the gear and avoid it falling down.
• First of all disconnect the machine from the electricity supply. Then loosen blade turning handle counter-
clockwise.
• Take out upper back lid by removing screws using the screwdriver. Loosen the three screw-nuts using a
10mm screw-wrench.
• Using the screwdriver turn the screw-nut ¼ counter-clockwise if the wheel is inclined towards the front or
turn it ¼ clockwise if it is inclined backwards. Tighten the three screw-nut previously loosen. Calibrate the
blade according to pre-operation.
• Turn the wheels manually to check if the blade is centralized, if it is not keep turning the wheels until the
blade is centralized.
CUTTING REGULATOR
• The cutting regulator (optional) was designed to provide cuts with the same thickness and also to protect
the operator from getting injured.
• To adjust the cutting regulator proceed as follows:
Turn locking knob counter-clockwise to be able to move the cutting regulator to the left and right according
to the distance you want to leave from it to the blade.
• Then turn the locking knob clockwise to fix the cutting regulator in the desired position.
CLEANING
First of all disconnect the machine from power source.
• Remove the upper door by unscrewing the screws of the hinges.