DMTA-20043-01EN [U8778624], Rev. B, May 2013
Overview of the OmniScan SX 31
Figure 2-8 Fastening hole location and specifications
To prevent equipment damage, apply the following instructions when attaching
accessories to the OmniScan SX or when mounting the OmniScan SX to any surface.
•
Use M4 × 0.7 mm screws with a nominal penetration length (into the instrument)
of 8 mm.
•
Make sure that air can circulate freely between the OmniScan SX’s heat sink and
the accessory or mounting surface.
•
When mounting the OmniScan SX to any surface:
— Always use the two fastening holes.
— Make sure that there is at least a 12 mm diameter surface contact area (see
Figure 2-9 on page 32) between the OmniScan SX and the supporting surface.
44 mm
97 mm
92 mm
33
m
m
59
mm
2 × M4
Содержание OmniScan SX
