Olympus OFP-2, Инструкция по эксплуатации

Страница: 54 / 64

Chapter 10 Troubleshooting
FLUSHING PUMP OFP-2
54
Chapter 10 Troubleshooting
Problem Possible cause Action
No power to the unit when
switched ON.
Power cable not connected
properly.
Check power cable is fully connected.
Fuse blown. Check fuses and replace as necessary.
Ensure the fuse drawer is pushed fully
home following any maintenance checks
or replacement.
No power from power supply. Check power supply.
Unit ON but poor / reduced
fluid flow.
Tube not fitted to pump properly. Check and fit tube to pump properly
(Refer to “Preparation for use” on
page 21).
Endoscope tube kinked or
blocked.
Replace with new tube.
Tube kinked or blocked. Replace with new tube.
Flow setting is low. Increase the flow setting.
Pump head has deteriorated. Measure the flow rate and replace with a
new pump head if it is insufficient.
Pump head lever has risen
during pumping.
Replace with a new pump head.
Unit ON but no fluid flow. Endoscope's auxiliary tube
kinked or blocked.
Replace with a new auxiliary tube.
Footswitch tube is disconnected,
damaged or poorly fitted.
Check that the footswitch tube is fully
connected.
Fluid container empty. Refill with sterile water.
Tube kinked or blocked. Replace with new tube.
Tube not fitted to pump properly. Check and fit tube to pump properly
(Refer to “Preparation for use” on
page 21).
Endoscope blocked. Check endoscope and correct.
Endoscope tube kinked or
blocked.
Replace with new tube.
Incorrect tube fitted. Check tubing and replace if necessary
with specified tube (see Section
“Consumable components” on page 14).
Pump head has deteriorated and
is unable to fill the endoscope
with water within 20 seconds.
Flush while holding down the pump head
lever with your finger.
Pump head lever has risen
during pumping.
Replace with a new pump head.
Unit is in ‘standby mode’. Make sure the pump head lever is closed
and the unit is placed in ‘run mode’.