DMTA-10040-01EN, Rev. E, February 2018
Chapter 5
196
Figure 5
‑
106 Adjusting the gain for frequency 2
10. Press the FREEZE key (
) to unfreeze the acquisition.
11. Press the DISP menu key (
), and then set the
DSP MODE
(A key) to
IMP
, set
the
CHANNEL
(B key) to
MIX
, and set the
POSITION
(C key) to
BOT RGHT
.
12. Place the probe again on position 1, and then press the A-LIFT NULL key (
).
13. Lift the probe into the air, press the MAIN FILTER menu key (
), and then,
while gently tapping the probe on position 1, decrease the
H GAIN
(D key) of
frequency 1 until the lift-off signal of the
MIX
channel is oriented nearly
horizontally (see Figure 5-107 on page 197).
If necessary, use the ERASE key (
) to clear the screen for easier adjustments.
Содержание nortec 600
