Olympus IPLEX FX IV8000-2, Инструкция по эксплуатации, Страница: 57 / 208

49
Chapter 3 Preparation and inspection before observation
„ Attaching the hook to the spring shaft
WARNING
• Be careful in handling the hook assembly so as not to avoid contact with your eye.
CAUTION
• Do not use the hook once detached from the spring shaft.
The hook is replaceable. To attach hook to the spring shaft, follow the procedure
below.
CAUTION
• If the hook is attached incorrectly, it can easily fall off. Read the following procedure carefully
before trying to attach the hook.
1
Check the screw thread at the distal end of the spring shaft. If the
end screws rattle or are misaligned, do not use the spring shaft and
use spare parts instead.
2
While gripping A in figure below with pliers, push the hook straight
over the spring shaft until it stops.
CAUTION
• After the hook hits the butting position, do not try to screw it in any further. Otherwise, hook
and the screw thread at the distal end of the spring shaft may be damaged.
•
Do not loosen the hook once it is attached to the spring shaft. If the hook is loose, replace it
with a new one. A loose hook can easily fall off.
Distal end screw
Usable Unusable
Distal
end
A
Proximal
end
Pliers