Olympus EVIS EXERA III, Инструкция по эксплуатации

Страница: 33 / 130

3.1 Precautions for installation and connection
27
CLV-190 INSTRUCTION MANUAL
Ch.3
Chapter 3 Installation and Connection
Prepare the light source and compatible equipment (shown in the “  System chart” on page 109)
before each use. Install and connect the equipment according to the procedures described in this
chapter and the instruction manuals for ancillary equipment.
WARNING
Review this chapter thoroughly and prepare the instruments properly before use. If
the equipment is not properly prepared before each use, equipment damage,
patient and operator injury, and/or a fire can occur.
CAUTION
• Turn OFF all system components before connecting them. Otherwise, equipment
damage or malfunction can result.
• Use appropriate cables only. Otherwise, equipment damage or malfunction can
result.
• Properly and securely connect all cables. If the cable connector has connection
screws, tighten up the screws. Otherwise, equipment damage or malfunction can
result.
• The cables should not be sharply bent, pulled, twisted, or crushed. Cable damage
can result.
• Never apply excessive force to connectors. This could damage the connectors.
• Use the light source only under the conditions described in, “Transportation,
storage, and operating environments” on page 113 and, “Specifications” on
page 113 in the Appendix. Improper performance, compromised safety and/or
equipment damage may result.
3.1 Precautions for installation and connection