HANDPIECE CLEANING
QUICK-REFERENCE GUIDE
Wipe the external surfaces of the handpiece, cord, and plug with enzymatic detergent, sterile water, or tap water
immediately after use.
MANUAL CLEANING
PRE-CLEANING
Fully immerse the handpiece, cord, and plug in the
cleaning solution. Allow them to soak for ten
minutes. Note the manufacturer’s instructions
regarding the temperature and dilution factor for the
detergent.
While immersed, gently scrub the areas shown below with the appropriate brushes (handpiece cleaning kit item EG70338009)
1
2
This is designed as a quick-reference guide only. This guide is not a substitute for reading and learning
the entire operator’s manual and/or instructions for use (IFU) provided the DIEGO ELITE System. Olympus
cannot encourage or recommend any actions that deviate from or are not covered by the IFU.
The gear shaft
The three-pin receptacle pocket and plug
The interior of the blade retention mechanism
The handpiece plug
