GENERAL
o
These luminaires are used indoors (ta 40 C)
where emergency light is needed. Each
luminaire must be permanently connected to
mains power supply. In normal operation the
power
indicator lights and the
charge
indicator
blinks to show that the batteries are in
charging condition. In case of a mains
power supply failure the
power
and the
charge
indicators turns off and the luminaire
will light the spot lamps automatically in
emergency mode. When the mains power
supply is restored the device turns to normal
operation.
INSTALLATION
To install the luminaire follow the installation
instructions οn page 3.
OPERATION
When the device is powered from the mains,
the
charge
indicator blinks and confirms the
charging of the batteries. When the batteries
are charged, it lights constantly. If it does not
light, probably, the batteries are disconnected.
If it does not light and the batteries are
connected, then contact the technician. As
long as the charge indicator blinks, the
batteries of the luminaire are charging and in
this period, any autonomy test must be
avoided. When the charging circle is
complete, the indicator lights continuously (it
can be used as an indication of a power
interruption). The batteries charging is done
by an 3 stages
technological advanced procedure, to ensure
the appropriate and full charging of the
batteries.
The
power
indicator confirms the proper
connection to the mains. The TEST button,
has a dual use. If pressed instantlly while the
device is connected to the mains, the device
simulates the power interruption, by lighting
the lamps for 3''. In this way, we can control
the driver circuit of the lamps and the lamps as
indicated in paragraph 3 in the text below.
Dimming option
When the voltage is interrupted, with
corresponding pressings of the button, we can
choose the illumination of 100%, 50%, 33% or
turned off, either to increase the autonomy time
or not to consume the battery power
unnecessarily. This option is canceled when the
network is restored.
ΑΤΤΕΝΤΙΟΝ!!!
1. Operations for installation, maintainance or
testing must be done by authorized personel
only.
Page 1 from 3
GRL-22
``POWER LIGHT`` SERIES NON-MAINTAINED EMERGENCY LUMINAIRE
923022100_09_006
Bayblend FR3010, transparent polycarbonate
TECHNICAL CHARACTERISTICS
(
for LED MODULE Specs. see page 2)
OPERATION TEMPERATURE RANGE
RELATIVE HUMIDITY
EXTERNAL DIMENSIONS
CONSTRUCTION MATERIALS
TYPICAL WEIGHT
GUARANTEE
OPERATION VOLTAGE
MAXIMUM POWER CONSUMPTION
BATTERY (Pb)
CHARGING TIME
INDICATIONS - CONTROLS
BATTERY PROTECTION
MINIMUM AUTONOMOUS DURATION
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
EMERGENCY ILLUMINATION
LIGHT SOURCE
<24h
Power indicator, battery charge indicator, TEST button
From overcharge and deep discharge
IP42
5 to 40 C
o
Up to 95%
3 years (1 year for the battery)
White LEDs
EN 60598-1, EN 60598-2-22, ΕΝ 55015, ΕΝ 61547, ΕΝ 61000-3-2, ΕΝ 61000-3-3
302 x 103 x 230 mm
220-240V AC/50-60Hz
600 min
12V/7Ah
710lm
16VA
3400gr.
Thank you for your trust in our products
Olympia Electronics - European manufacturer