GR-750x series
Control panel for addressable
emergency luminaires
Document number:
923750400_90_001_EN
Date: 25/5/2023
Page: 9 of 15
[9]
2.4 Configure point address
A valid (1-250) and unique address (per loop) must be set for each point, using the onboard address selection
DIP switch on each point.
Certain models, such as ZLD-xx, GR-29X, do not have onboard DIP switches. In this case, the address must
be set using the panel by connecting and setting the luminaires one-by-one from the
CHANGE POINT
ADDRESS
menu.
For more information on the point’s
address configuration, refer to the manual of the specific luminaire.
It is essential to draw a schematic of the installation. The schematic should include cable length, cable cross-
section, and the location of each point. It could be useful for the maintenance of the installation and an efficient
way to locate a faulty point or line problem.
Figure 7 - Example of an address selection DIP switch on a luminaire