EN
13
Battery LED display
Battery
charge
Indication/Action
No light
50
—100 %
Battery OK
Blinking with the fence
LED
Under 50 %
It would be a good idea to charge the battery
Blinking with double
speed
Under 25 %
Charge the battery now
Continuous fast
blinking
Empty
The deep discharge protection is active.
Charge battery immediately to avoid damage.
IMPORTANT:
If the red pulse LED lights for a longer time before starting pulsing, the
energiser may have an operation problem. Disconnect the battery, wait for a moment
and start the energiser again. If the situation repeats, deliver the energiser to service.
3.1.2. Using the WZG 180 B with WZG solar panel
IMPORTANT:
The full installation instruction is included the WZG solar panel kit.
The 20
W WZG solar panel kit has a lead kit with battery clamps. Connect the battery clamps of the
energiser and the solar panel both to the poles of the battery, the red marked connectors to
the plus pole and the black marked connectors to the minus pole. The charging current flows
now directly from the solar panel to the battery. Disconnect the solar panel from the battery if
the energiser is not being used for a period of a week or more. If you discover that the battery
has over heated due to over charging, disconnect the solar panel from the battery and let the
energiser discharge the battery for a while before re-connecting the solar panel.
IMPORTANT:
If you want to check the battery status in solar panel use, you need to
disconnect the solar panel or do the check when the panel is not charging. When the
battery is being charged, the battery voltage can not be used to indicate the charging
state of the battery.
3.1.3. Connecting WZG 180B to the fence
Push down the red button of the fence connector
and push the stripped fence connection
lead end into the connector from below. Ensure the connection by pulling the wire lightly.
Install the earthing wire to the black earth connector in the same way. The red fence
connector is marked with a lightning symbol and the black earth connector is marked with an
earth symbol
.
IMPORTANT:
The fence voltage can be up to 10 000 Volt. Therefore all
connectors from the energiser to the fence must be mounted on fence insulators or the
connector cable shall be a special high voltage cable that is designed for electric fence
use, like WZG the high voltage cable. Normal 230 V installation cables shall not be
used for fence installations.
3.2 WZG 250B+
In the front panel you can find the indicator of the operation mode (1), power and mode
selection button (MODE, 2), light sensor (3), LED bar indicator for the battery voltage (4) and
a LED bar indicator for the fence voltage (5). The fence voltage is shown in Kilovolts (1 kV =
1000V).
