Olivetti XZAC4219-03 PR2 plus, Руководство по обслуживанию, Страница: 78 / 160

XZAC4219-03 Service Manual 4-25
This calibration makes it possible to set the distance between the left-hand edge of the document and the first
character printed.
The value of the left-hand margin will always be used without the need for configurations from Set-up.
To carry out this calibration, proceed as follows:
1. Switch on the printer with the cover open holding down the three console buttons.
2. Wait for the acoustic signal that indicates access to the calibration and adjustment procedure.
3. Press the Local button and wait until the end of the machine reset procedure.
4. Press the Station 2 button.
5. Press the Station 1 button until a long two-tone signal is heard (different from the previous
signals).
6. Insert an A4 sheet and wait for the page to be printed. Check that the left-hand margin is set to
the measurement required.
7. The minimum distance between the left-hand edge of the document and start of the character
must be max. 0.5 mm with calibration from console completely to the left. If this situation does
not occur, revise adjustment of the photosensor.
8. Check as described in point 7.
9. Pressing the Station 2 button, bring the left-hand margin towards the right until the set
measurement of 6.95 ± 0,55 mm of the TEMPLATE code 473284Z is reached (check carried out
inserting an A4 sheet).
10. Press the Local button twice.