Olivetti PR2 PLUS, Руководство по обслуживанию, Страница: 38 / 172

2-10 Service Manual
XZAC4219-05
Installing the printer
WARNING:
make sure that the voltage indicated on the data plate matches that of the local power
supply.
1.
Position the machine where it is to be used, checking compliance with the indications provided in section
“GENERAL INFORMATION FOR INSTALLATION” on page 2 - 1 .
2. Connect the mains cable and switch on the printer.
3.
Check power-on through the mechanism reset phase and
lighting up of the ON led on the console.
4.
If other LEDs apart from the ON LED remain on, refer to
section
“ERROR MESSAGES” on page 5 - 1 .
OFF-LINE TEST
A print test can be carried out to check functioning of the printer before connecting it to the system.
Activating and deactivating the print test
To activate the test, proceed as follows:
1. Switch off the printer.
2.
Switch on the printer holding down the STATION 2 key
of the console.
3. At the end of the initialization phase, insert an A4 sheet in the
introduction slot until the paper alignment photosensor is
activated.
4. The machine automatically feeds the sheet and prints the test. The sheet is ejected automatically at the end of
the test. To repeat printing, simply insert a new sheet.
The print test provides the following information:
•
·The release and version of the firmware.
•
The presence and type of scanner installed.
•
The presence and type of magnetic options used.
•
A visual check of the operation of the 24 printhead needles.
•
The parameter settings for the emulations used.
•
The configuration parameters currently programmed for the printer.
Visually checking the writing allows also an evaluation of the printing quality.
An example of the information returned by the test is provided on the next page. The contents of the test depend on
the FW release installed on the printer.
Disactivating the test
To de-activate the test, switch off the printer.