Olivetti PR2 PLUS, Руководство по обслуживанию, Страница: 111 / 172

XZAC4219-05 Service Manual
6-7
Adjusting parallelism of print bar (without torsion bar)
•
MACHINE STATUS
Printer switched off and without casing.
•
CONDITIONS TO BE CHECKED
Check print bar parallelism.
•
PROCEDURE
–
The bar perpendicularity adjustment lever (1) can be pre-regulated with tool code 9600303 according to
drawing code 395130U.
–
For manual adjustment of the parallelism between the head and the print bar, rotate studs (2) counter
clockwise to move the bar close to the front of the matrix; rotate clockwise to move the bar to the rear of the
matrix.
–
The parallelism indicator (3) can be used to check whether the corrections have been made.
–
Move the carriage completely to the left and, using a comparator, push the print bar close to the feeler roller
with a dynamometer. A load of 350 g ± 20 g must correspond to a movement of 0.35 - 0.45 mm. Repeat the
procedure on the right of the bar. Repeat the procedure for every adjustment screw of the bar.
Figure 6 - 6 Adjusting parallelism of print bar
2
3 1
300 g + 20 g 300 g + 20 g 300 g + 20 g 300 g + 20 g