2-41
Installing and Setting up the Machine > Energy Saver Function
Sleep
To enter Sleep, select the [
Energy Saver
] key. Touch panel and all indicators on the operation panel will go out to save
a maximum amount of power except the Energy Saver indicator. This status is referred to as Sleep.
If print data is received during Sleep, the machine automatically wakes up and starts printing.
Also when fax data arrives while the machine is in Sleep, the machine automatically wakes up and starts printing.
When Using the Machine
Automatically wakes up when someone approaches the machine while the Motion Sensor is being used.
For more information on Motion Sensor settings, refer to the following:
If the Motion Sensor is not being used, perform one of the following actions.
• Select any key on the operation panel.
• Touch the touch panel.
• Open the optional original cover or the optional document processor.
• Place originals in the optional document processor.
Recovery time from Low Power Mode is as follows.
• Within 14.4 seconds
Note that ambient environmental conditions, such as ventilation, may cause the machine to respond more slowly.
Auto Sleep
Auto Sleep automatically switches the machine into Sleep if left idle for a preset time.
The amount of time before entering Sleep is as follows.
• 10 minutes (default setting).
To change the preset sleep time, refer to the following:
Energy Saver Setup (page 2-44)
Sleep Rules (models for Europe)
You can set whether Sleep Mode operates for each function. When the machine enters Sleep Mode, the ID card cannot
be recognized.
For more information on Sleep Rules settings, refer to the following:
Sleep Rules (models for Europe) (page 8-78)
NOTE
If the Low Power Timer is equal to the Sleep Timer, a Sleep Mode is preceded.
Energy Saver indicator