Olivetti d-color MF651, Руководство по обслуживанию, Страница: 664 / 1053

12. SERVICE MODE Field Service Ver. 2.0 Jul. 2009
604
ADJUSTMENT
/ SETTING
12.16.9 FS-FN adjustment - Punch Regist Loop Size (Body)
A. Use
• Adjusts the punch loop size used for paper exited from the main body.
• To address problems such as misaligned punch holes, wrinkled paper, and jam at the
punch registration section.
B. Procedure
1. Call the Service Mode to the screen.
2. Touch [Finisher]
o
[FS-FN adjustment]
o
[Punch Regist Loop Size (Body)].
3. Touch the paper size where punch regist loop size is adjusted.
4. Set the correction value using the [+]/[-] keys.
Misaligned punched holes: Enter the value of [+]
Wrinkled paper: Enter the value of [-]
Setting range: -5.0 mm to +5.0 mm (Step = 0.1 mm)
5. Touch [OK] twice.
6. Touch [Exit] on the Service Mode screen.
7. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
12.16.10 FS-FN adjustment - Punch Resist Loop Size (PI)
A. Use
• To adjust the loop size used for punch registration in the post inserter upper and lower
trays.
• To address problems such as misaligned punch holes, wrinkled paper, and jam at the
punch registration section.
B. Procedure
1. Call the Service Mode to the screen.
2. Touch [Finisher] o [FS-FN adjustment] o [Punch Regist Loop Size (PI)].
3. Touch [Upper] or [Lower].
4. Select a type of paper where adjustment is made.
5. Set the correction value using the [+]/[-] keys.
Misaligned punched holes: Enter the value of [+]
Wrinkled paper: Enter the value of [-]
Setting range: -5.0 mm to +5.0 mm (Step = 0.1 mm)
6. Touch [OK] twice.
7. Touch [Exit] on the Service Mode screen.
8. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
Service Manual Y110571-1