Olivetti d-color MF651, Руководство по обслуживанию, Страница: 667 / 1053

Field Service Ver. 2.0 Jul. 2009 12. SERVICE MODE
607
ADJUSTMENT
/ SETTING
12.16.13 FS-FN adjustment - Center-staple pitch adjustment
A. Use
• Adjust the interval between two staples in saddle stitching.
B. Procedure
1. Place two sheets of originals on the ADF.
2. Make a set of copy in the two position saddle stitching mode.
3. Measure the interval (A) between the two staples on the copy.
Specification: Paper width of less than 245.3 mm: 42.5 mm ± 3.0 mm
Paper width of 245.3 mm or more: 60.0 mm ± 3.0 mm
Adjustment range: -38.0 mm to +3.0 mm (1 step: 1 mm)
4. Call the Service Mode to the screen.
5. Touch [Finisher]
o
[FS-FN adjustment]
o
[Center-staple pitch adjustment].
6. Touch the paper size where saddle stitching pitch is adjusted.
7. Set and adjust a value with the [+]/[-] key.
To make width (A) greater : Enter the value of [+]
To make width (A) smaller : Enter the value of [-]
8. Press the Reset key.
9. Touch [Exit] on the Service Mode screen.
10. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
11. Make a copy again and check the interval between the staples.
12.16.14 FS-FN adjustment - PI Size Detection
A. Use
• To specify paper sizes that the post inserter detects.
• To set a paper size with which size detection is made when a paper having a similar size
is placed on the feeder.
B. Procedure
1. Call the Service Mode to the screen.
2. Touch [Finisher]
o
[FS-FN adjustment]
o
[PI Size Detection].
3. Touch [Mode 1].
4. Select a desired paper size with which size detection is made.
5. Make the same setting in [Mode 2] to [Mode 6].
6. Touch [OK] twice.
7. Touch [Exit] on the Service Mode screen.
8. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
A
A
A11RF3C501DA
Y110571-1 Service Manual