Olivetti d-color MF651, Руководство по обслуживанию, Страница: 372 / 1053

10. UTILITY Field Service Ver. 2.0 Jul. 2009
312
ADJUSTMENT
/ SETTING
(2) Centering
• It will not be displayed when the following setting shows that Management Device 1 is
mounted during the device power is OFF or no authentication is set.
[Service Mode]
o [Billing Setting] o [Management Function Choice]
• This menu is unavailable when the key counter is not inserted while only the key counter
is set to Set by [Service Mode]
o
[Billing Setting]
o
[Management Function Choice].
<Use>
• To vary the print start position in the main scan direction for each paper source.
• The PH unit has been replaced.
• A paper feed unit has been added.
• The print image deviates in the main scan direction.
<Procedure>
Width A on the test print produced should fall within the following range.
Specifications: 3.0 r 0.5 mm
Setting range: -3.0 mm to +3.0 mm (in 0.2 mm increments)
1. Call the Administrator Settings to the screen.
2. Touch [System Settings]
o
[Expert Adjustment]
o
[Printer Adjustment]
o
[Centering].
3. Select the paper source to be adjusted.
4. Press the Start key to let the machine produce a test print.
5. Check the dimension of width A on the test print.
6. If width A falls outside the specified range, change the setting using the [+] / [-] key.
If width A is longer than the specifications, make the setting value smaller than the cur-
rent one.
If width A is shorter than the specifications, make the setting value greater than the cur-
rent one.
7. Press the Start key to let the machine produce a test print.
8. Check the dimension of width A on the test print.
9. If width A is outside the specified range, change the setting again and make a check
again.
10. If width A falls within the specified range, touch [OK].
11. Following the same procedure, adjust for all other paper sources.
(Use A4 or 8
1
/
2
× 11 plain paper for the bypass.)
A0P0F3C504DA
Width A
Service Manual Y110571-1