PA102200CR/PA102206MB/PA102200BN installation instructions.pdf
Installation Instructions
A
B
D
E
C
Max 18mm 1/2BSP thread
Issue Date 30/11/2018 Revision Number: V1.0
Installation Instructions
1. Remove product from packaging and check for damages, if the product is damaged do not install and
return to store of purchase.
2. Ensure Product is complete as per exploded drawing.
3. Apply sufficient thread seal tape to the ½”bsp thread. (do not overload thread with thread seal tape as
this will put undue pressure on bath spout (D).
4. Slide wall plate (B) onto ½” BSP thread ensuring sealing rubber (A) is in place on the back of the wall
plate (B).
5. Screw Wall Basin/Bath Spout (C) onto ½”bsp thread.
General Note:
This product is to be installed by a licensed plumber, installation must comply with AS/NZS
3500 and local plumbing codes.
°
C
Pressures & Temperatures
Maximum Hydrostatic Pressure – 500 kpa. (As per AS/NZS3500)
Note: AS/NZS 3500.1-2003 (Clause 3.3.4) states that “Provision shall be made to ensure that the
maximum static pressure at any outlet, other than a fire service outlet, within a building does not
exceed 500 kPa.
Note: Pressures above 500kPa can cause damage from water hammer, reduced life of appliances,
taps and fittings, and cause excessive noise in the system.
Minimum Hydrostatic Pressure – 100 kpa
The Maximum operating temperature for the Mixer Tap is 65 .
Please ensure that the lines are flushed prior to installation as contaminates in the water can damage the
Aerator and also affect the performance of the product.
To the consumer
Under No Circumstances
should any abrasive, cream or acid based cleaning agents be used as these
types of cleaners will damage the finish, seals and aerators.
1. The bath spout is to only be cleaned with warm soapy water.
2.
N.B The Wall Basin/Bath spout is pre-fitted with a flow regulated aerator. If the spout is being
used over a bath, the aerator is to be removed by Aerator key (E) and then fitted with open flow
regulator (D).