Dust Chute Assembly
Mount the dust chute (A, Figure 2) to the planer
hood with eight M6x10 hex head screws (B,
Figure 2). Make sure the dust collection system
has sufficient capacity and suction for your
planer. Always turn on the dust collection
system before starting the planer.
Table Roller Handle Assembly
Thread the handle (C, Figure 3) into the hub.
Control Panel
D.
Emergency Stop Button:
Stops all
functions of machine, but the planer still has
power. To reset rotate switch clockwise until
the button pops out.
E.
Main Motor:
Starts rotation of cutterhead.
Will not work if the “Emergency Stop” switch
is engaged, or hood is open.
F.
Digital Thickness Controls:
Displays and
controls table position, units, etc..
G.
Table Up:
Raises the table.
Note:
Table
will contact the upper limit switch at about
5/8” and will automatically shut down. You
can continue to raise manually by using the
handwheel.
H.
Table Down:
Lowers the table.
Note:
Table will contact the lower limit switch at
about 8-5/8” and will automatically shut
down. You can continue to lower manually
by using the handwheel.
Digital Controller
I.
LED readout displays the thickness setting.
J. The digital thickness controls are capable of
operating and displaying in either inches, or
millimeters by pressing the “Units” button.
K. The “+” and “-“ buttons can be used to move
the table up or down without keying in an
exact numerical thickness value.
Note:
The
“-“ button raises the table to subtract from
workpiece thickness. The “+“ button lowers
the table.
L. “Start” button is used to begin table travel
after a numeric value has been keyed in.
M. The “Stop” button is used to stop the table
travel after it has started.
N. The “Set” button is used when calibrating or
setting the thickness scale.
9
