Oliver 2019, Руководство пользователя

Страница: 24 / 56

24 | Page Oliver Machinery 2019 Lathe
Test Run
This lathe has been inspected and calibrated before leaving the factory to meet our quality and precision
standards. Due to various reasons, the machine may need to be readjusted when it arrives at your
workshop. It is recommended to complete the test run before using the lathe for production work. Repeat
the test run if the lathe is relocated.
Step 1: Verify that the lathe is mechanically functional.
1. Install the spur center into the headstock and the live center into the tailstock.
2. Move the tailstock towards the headstock until the tips of the centers are about 3 ” apart.
3. Use the tailstock lock to s ecure the tailstock on the bed. Rock the tailstock to ensure there’s
enough clamping force to hold the tailstock in place.
4. Extend the tailstock quill so the tips of the centers are almost
touching each other. If the tips of the centers are aligned, the
headstock and tailstock are aligned.
5. Retract the tailstock quill beyond the 0” po sition. Ensure the
live center is extracted from the quill.
6. Secure the tool rest on the banjo, then use the banjo lock to clamp the banjo on the lathe bed.
Rock the tool rest and make sure it is locked in place. The tool rest must firmly support the lathe
tool and must not shift when turning wood.
7. Engage the spindle lock and rotate the spindle to make sure the lock works, then disengage the
spindle lock.
Step 2: Verify that all electrical components are functional.
1. Remove all tools and debris from the lathe.
2. Press the STOP button on the control panel.
3. Set the spindle speed to the lowest.
4. Set the spindle direction to forward (FOR).
5. Connect the machine to the power source. The variable
frequency drive and its heat dissipation fan should turn on. The
green ready light should turn on.
6. Press the START button. The spindle should rotate counterclockwise on the inboard side of the
lathe with no excessive noise or vibration.
7. Disconnect the machine from the power source while the machine is running, then reconnect the
machine to power. The alarm light should turn on, and the motor should
NOT restart.
8. Press the STOP button to clear the alarm, then press the START button to restart the machine.
9. Rotate the spindle speed dial to increase the speed to maximum, then reduce the speed back to
the lowest. The lathe should run without excessive vibration or noise at any particular speed, and
the digital readout should indicate the spindle speed.
10. Press the STOP button to stop the machine.
11. Turn the spindle direction switch to change the direction to reverse (REV).
12. Press the START button to start the motor.
13. The spindle should rotate clockwise on the inboard side of the lathe. Run the lathe at different
speeds, and it should run with no excessive noise or vibration.
14. Press STOP on the control panel to stop the motor and end the test run.
Congratulations! Your lathe has completed the test run. If you discover any issues, please refer to the
troubleshooting and maintenance sections for adjustment instructions.