Oliver 2019, Руководство пользователя

Страница: 10 / 56

10 | Page Oliver Machinery 2019 Lathe
Safety
Oliver Machinery has made every attempt to provide a safe, reliable, easy-to-use piece of machinery.
Safety, however, is ultimately depending on the individual machine operator.
Before operating this
machine, please become familiar with the following safety labels and guidelines.
DANGER
This indicates an imminently hazardous situation that must avoid, or it WILL cause
death or severe injury.
WARNING
This means if the warning is not taken seriously, it CAN cause death or severe injury.
CAUTION
This means if the precaution is not taken, it MAY cause injury.
IMPORTANT This is a tip for properly operating the machine to avoid machine damage.
General Safety Guidelines
1. FAMILIARIZE yourself with all safety instructions found in this manual. Know the limitations and
hazards associated with this machine. Do not operate or service this machine until you are properly
trained.
2. ELECTRICAL GROUNDING , when done correctly, reduces the risk of electrocution, shocks, and fire.
Make certain that the machine frame is electrically grounded and that a ground lead is included in the
incoming electrical service. In cases where a cord and a plug are used, ensure that the grounding plug
connects to a suitable ground. Follow the grounding procedure indicated in the electrical code of your
area.
3. DISCONNECT the machine from power before performing any service, maintenance, or adjustments.
A machine under repair should be RED TAGGED to show it should not be used until the repair is
complete.
4. GUARDS : Keep machine guards in place for all applicable operations. If any guards are removed for
maintenance, DO NOT OPERATE the machine until all guards are reinstalled. Check clearance between
the guards and the cutter before starting the machine.
5. ACCESS DOORS/PANELS : If a machine is equipped with access doors and panels for maintenance and
service purposes, the access doors and panels must be closed before starting the machine.
6. WORKPLACE SAFETY : Keep the floor around the machine clean. Scrap material, sawdust, oil, and
other liquids increase the risk of tripping or slipping. Be sure to clean up the table before starting the
machine. Ensure the work area is well-lighted, and a proper exhaust system is used to minimize dust.
Use anti-skid floor strips on the floor area where the operator typically stands and mark off the
machine work area. Provide adequate workspace around the machine.
7. REPLACEMENT PARTS: Use only genuine Oliver Machinery replacement parts and accessories
recommended for this machine. Generic parts made by other manufacturers may create a safety
hazard and WILL void the factory warranty and other guarantees.
8. PROPER USE: Do not use this machine for anything other than its intended use. If used for other
purposes, Oliver Machinery disclaims any real or implied warranty and holds itself harmless for any
injury or damage which may result from that use.