Oliver 10047VS, Руководство пользователя, Страница: 14 / 58

14 |
Page Oliver Machinery 10047VS Shaper
Electricals
WARNING
All electrical work must be done by a qualified electrician, and must meet the
electrical code in your area.
Minimum Circuit Size Required for Model 10047VS Shaper
Stock Number Minimum Circuit Size Required
10047VS.001 30A
Please ensure the electrical circuit for this machine meets the minimum circuit size requirement.
Minimum circuit size requirement applies to a dedicated circuit which provides power to one 10047VS
Shaper. If more machines are sharing the same circuit, consult a qualified electrician to ensure the
designated circuit is properly sized for safe operation.
If a circuit is available, but not meeting the minimum circuit size requirement listed above, a new circuit
must be installed for this machine.
Grounding
WARNING
Improper grounding can cause electric shock, fire, and equipment damage.
Proper grounding reduces the risk to the operator in the event of electrical malfunction or breakdown.
This machine must be connected to the grounding conductor when available, and all grounding
connections must meet or exceed the electrical code requirements in your area. Furthermore, all grounds
must be verified and must meet or exceed the electrical requirement of the machine. If grounding is not
available, consider the use of a GFCI protection device as an alternative, if this complies with the electric
code in your area.
Electrical Wiring
This machine is pre-wired for 230V with a cord and a NEMA L6-30 plug. Use of extension cord is not
recommended. If you need to use an extension cord to connect to a power source, select a durable cord
type with high temperature rating (90C° or above). Use minimum amount of extension cord as needed.
Minimum cord size (AWG) required based on amperage draw and length of the cord:
Amps Power Cord Length
25 feet 50 feet 75 feet 100 feet
8 to 12 14 14 12 10
12 to 15 12 12 10 10
15 to 20 10 10 10 NR
21 to 30 10 NR NR NR
*NR: Not Recommended
WARNING
Use properly sized wires that meet or exceed the power requirement of your
machine. Using undersized wires may cause overheating and increase the risk of fire
and machine damage.