OLIMEX© 2015
iMX233-OLinuXino-NANO user's manual
Reset button –
used to reset the board
Power button
– when Linux is running pressing PWR_BUT will put the board in low power mode;
when powered by battery PWR_BUT is used to initially power up the board – and pressing the
board again after it is powered will put it low power mode
Recovery button –
when powered by battery the recovery button is used to bring the processor to
normal power mode
512 (32M x 16) MBit DDR SDRAM –
the exact memory used at the moment of writing is Xylinx
H5DU5xxxyyy
Green LED1
6.11 Accessories
Here you will find additional information for Olimex products you can use with OLinuXino-NANO
purchase
6.11.1 USB-SERIAL-CABLE-F
The cable for the U_DEBUG interface that can be purchased for additional cost has three cables. It
is important to specify in your purchase order whether you want the USB-SERIAL-CABLE-F
variant with male of female connectors.
You will need a drivers that can be downloaded from the page of USB-SERIAL-CABLE:
https://www.olimex.com/Products/Components/Cables/USB-Serial-Cable/USB-Serial-Cable-F/
Page 29 of 36
