User Manual LR-1BS35
OMEN-1BS35-202012
14
Figure 15 Interface of software upgrade
-3. After clicking the ‘Upgrade’ button, power on the radar again and the firmware write
operation will be executed.
-4. Check the ‘Continuous mode’ option, after the upgrade, it will automatically wait for the next
upgrade, which can be used to upgrade radar firmware in batches.
Appendix E Suggestions on Mechanical Installation
When installing lidar, pay attention to the following points:
1. Please remove the transparent protective film on the window when using it on site.
2. Try best to avoid shock and vibration.
3. Keep it away from any direct sunlight (windows, skylights) or any other heat source to
prevent the internal temperature of the device from rising.
4. It is recommended that the mounting base used to fix the lidar be as flat as possible.
5. The positioning column on the mounting base should strictly follow the depth of the
positioning column at the bottom of the lidar, and should not be higher than 4mm. It is
recommended to use aluminum alloy mounting base for better heat dissipation .
6. When installing the lidar, if the lidar has contact mounting surfaces on both top and bottom,
please make sure that the distance between the mounting surfaces is larger than the height of
the lidar to avoid squeezing the lidar.
7. The tilt angle should not exceed 90 degrees when the lidar is installed. If the tilt angle is too
large, it will affect the life of the lidar.
8. When arrange the wiring of the lidar, wiring on the radar should not be too tight; keep the
wiring loose.
In order to avoid any influence to the measurement accuracy due to mutual interference
between lidars, we recommend the following installation, taking LR-1BS as an example. (Α≥6°,
H≥200mm, the position of the line segment in the diagram represents the lidar emission position)
