Oldham CPS Series, Руководство пользователя

Страница: 47 / 76

CPS
– User Manual
Page 47
Chapter 6 Maintenance
Program transfer
This chapter describes the transfer of data from the COM _CPS application to the CPS, and vice
versa (see the COM _CPS user
’s guide). After launching the software, you will see a welcome
window.
PC

CPS transfer
Once the program has been created, the central controller should receive new settings..
Step 1: establish a physical connection
1) Use either the USB or RS-232 adapter to connect the PC to the CPS central measuring
controller.
2) Ensure that the CPS central measuring controller is connected to a power source.
3) On the central controller : flip the programming switch to the
“MEM” position. The message
“Switch open – Program…” will appear on the display screen. Communication with the central
controller is authorized during this phase..
Step 2: link configuration
1) In the menu bar, select [Communication > Port].
2) Select the port [COM x] to use on the PC.
Note : communication speed is selected automatically.
Step 3: data transfer
1) In the menu bar, select [Transfer > from PC to CPS].The message "Flip switch to MEM position
in order to reprogram the central controller” refers to the <MEM> position on the CPS central
controller commutator before starting the transfer procedClick [OK] once verification has ended.
2) During the transfer, a progress bar will indicate transfer progress.
3) Once the transfer is complete, the message
“Operation complete” will appear on screen. Click
[OK]. The configuration program has been transferred from the PC to the CPS central
controller.
4) On the central controller : The message
“Switch open – Complete” will appear on the display
screen. Flip the programming switch to the
“Prog” position.
5) The central controller will perform a
“Start-up” procedure.
CPS

PC transfer
Step 1: establish a connection
1) Use either the USB or RS-232 adapter to connect the PC to the CPS central controller.
2) Ensure that the CPS central measuring controller is connected to a power source.
4)
On the central controller : flip the programming switch to the
“MEM” position. The message
“Switch open – Program…” will appear on the display screen. Communication with the central
controller is authorized during this phase.
Or, use the
“Control” menu to set the printer to “OFF.”
Step 2: link configuration
1) In the menu bar, select [Communication > Port].
2) Select the port [COM x] to use on the PC.
Note: communication speed is selected automatically.
Step 3: data transfer
1) In the menu bar, select [Transfer > from CPS to PC].
2) The message,
“Do you want to read the CPS central controller configuration?” will appear
onscreen. Click [OK]. If the message,
“Check port configuration and ensure printer set to OFF
position and try again
” appears, verify that the CPS printer is in the OFF position.
3) Select the folder where you want to download the file, and create a file name (a default name is
suggested).
4) During the transfer, a progress bar will indicate transfer progress.
5) Once the transfer is complete, the message
“Operation complete” will appear on screen .
Click
[OK]. The data has been transferred from the CPS central controller to the PC.
6) On the central controller : The message
“Switch open – Complete” will appear on the display
screen. Flip the programming switch to the
“Prog” position.
7) The central controller will perform a
“Start-up” procedure.