Introduction
01
heatboss
®
thermostat is an intelligent wireless temperature,
humidity and movement sensor. It is installed in a room to
monitor and control the heating along with heatboss
®
wireless valve.
Pre-install
02
•
Determine if the heatboss
®
thermostat is going to be
powered from the mains power supply, if so, the
thermostat P ower Module will need to be installed. The
m odule will be installed inside a single gang wall socket.
•
S crew/stick the white back plate
o nto an internal wall. Ensu re that it is
m ounted level with the arrow pointing
upwards and away from heat sources.
e .g. radiators, electric heaters, direct
sunlight, doors, draughts etc.
•
Ensure thermostat has good air
c irculation and mounted 1.4m from
the ground.
Display Symbols
05
Customise Schedules
04
Install
03
•
Log on to heatboss® user interface.
•
Select Zone, Rooms & Controllers
from the dropdown menu.
•
Select the desired room you want to
install the thermostat to and click “add
device”
•
Pull out battery tab on thermostat and
mount onto back plate, then attach
both screws.
•
The thermostat will scan for the hub,
this takes up to 30 s econds, whilst
this is happening the stat will
display the symbol to the right.
•
After around 30 seconds the stat will display...
•
The thermostat is now successfully installed.
Thermostat Installaton Guide
S canning for hub
S ynchronised to hub/
operation sucessf ul
Reset in operation
Battery low / battery
mode selected
Main mode selected
S et-up c omplete
Network loss
Child lock - Stat input
is locked out and can
only be unlokced from
user interface
S tat disabled - No
schedule will be
run. Re-enable from
user interface
then
All LEDs flashing
Factory reset performed
Green illuminated when
setting target temperature
Within Eco range i.e. 17 - 19°C
Yellow illuminated when
setting target temperature
Within 19 - 22°C
Red illuminated when
setting target temperature
High i.e. 22°C +
Yellow flashes once per minute
Battery low
1.4m
•
On the heatboss
®
user interface you c an now set on/off
times and temperatures for the room the thermostat is
linked to.
•
S imply click the icon and create schedules.
•
These schedules will be sent wirelessly to the thermostat within
10 minutes (at the very most).
