OKM FS Future GeoSeeker Mini, Руководство пользователя

Страница: 36 / 52

36 Conducting a measurement
• After one scan point has been measured completely at
all depths both the Voltage Electrodes (black socket)
and the Power Electrodes (red socket) as well as the
control unit needs to be moved to the next scan point
(left to the current one).
After recording all measured values in all scan points the screen will display a graphical 2d
representation of the measured values as shown in figure 7.2 on page 45.
6.3 Setting up a measurement
While preparing your measurement you will set up your scan point markers, place the control unit to its
initial position and put the electrodes into the ground as indicated by the GeoSeeker Mini measurement
screen.
Please follow these basic steps to prepare your measurement:
1. Investigate your scan field and find out how you are going to process your measurement.
2. Prepare your scan field with scan point markers.
3. Prepare your control unit and start a new measurement. Adjust all parameters according to your
field preparation.
4. Place the control unit at the first scan point (the one on the right side) and put the Voltage
Electrodes according to the device's instructions into the underground.
5. Also put the Voltage Electrodes according to the device's instructions into the underground.
6. Start measuring the first scan point and follow the device's instructions until your measurement
has been completed successfully.
6.3.1 Setting up your scan field with markers
After investigating your area you should place markers at each scan point. The distance of your 3 or 5
scan points can vary from situation to situation. The picture from figure 6.2 on page 33 shows an
example of how to mark your scan points.
OKM GmbH
www.okmmetaldetectors.com