OKIDATA DOC-IT3000, Руководство по обслуживанию

Страница: 136 / 428

Page: 88
Service Guide DOC-IT3000/4000
Chapter 3 Maintenance & Disassembly
3.2.03 Transfer Charger Assembly
Note:
Make sure the image drum cartridge is removed before performing this procedure.
The image drum cartridge must be protected from light when it is not installed.
· Open the stacker cover.
· Open the LED holder.
· Firmly push down, then back, on both sides (1) of the transfer charger assembly (2) until
the square holes on each end of the transfer charger assembly disengage from the claws
of the base.
CAUTION:
When removing the transfer charger assembly, be careful not to break the tabs.
· Lift and remove the transfer charger assembly.
· Remove the end caps of the transfer charger assembly.
· Using a needle nose pliers, detach the spring.
· Detach the transfer wire from the clip and remove.
· When installing the transfer wire, place it so the notch matches the dot in the diagram
engraved at the bottom of the assembly.
CAUTION:
When installing the transfer charger assembly, make sure the assembly is locked under the
claws.
If the assembly is not locked, the image drum will be scratched.
Note:
When cleaning the transfer wire, use the cleaning tool (3) located under the LED holder
Refer to Section 3.4, of this Service Handbook for further cleaning information ( ).
P/N 53528001 Transfer Wire Cleaner B.2.03
P/N 50087401 Charger: Transfer (Assembly) RSPL B.2.06