OKILAN 6020E PLUS INSTALLATION GUIDE
SAFETY AND REGULATORY NOTICES
17
S
AFETY
AND
R
EGULATORY
N
OTICES
FCC R
ADIO
F
REQUENCY
I
NTERFERENCE
S
TATEMENT
This equipment has been tested and found to comply with the limits
for a Class B digital device pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio or television reception. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause interference to radio and
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver,
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
W
ARNING
The connection of a non-shielded equipment interface cable to this
equipment will invalidate the FCC Certification of this device and
may cause interference levels which exceed the limits established by
the FCC for this equipment. It is the responsibility of the user to
obtain and use a shielded equipment interface cable with this device.
If this equipment has more than one interface connector, do not
leave cables connected to unused interfaces. Changes or
modifications not expressly approved by the manufacturer could
void the user's authority to operate the equipment.
