6 - English
Regulatory Information
Year 2000 Compliance
This product is Year 2000 Compliant. It contains information
technology that accurately processes date and time data
between the years 1999 and 2000, and carries no issue for
the September 9, 1999 (9999) programming concern. This
product, when used in combination with products purchased
from other manufacturers, whose products properly
exchange data and time information, will accurately process
the date and time.
Federal Communications Commission (FCC)
Declaration of Conformity
1. Product Identification
2. Statement
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
3. Responsible Party
Oki Data Americas, Inc.
2000 Bishops Gate Boulevard
Mt. Laurel, NJ 08054-4620
1-800-654-3282 (1-800-OKI-DATA)
FCC Administrative Council for Terminal
Attachment Requirements for End Users
This device has been granted a registration number by the
Administrative Council for Terminal Attachment (ACTA),
under Part 68 and ACTA rules and regulations for direct
connection to the telephone lines. In order to comply with
these FCC rules, the following instructions must be carefully
read and applicable portions followed completely.
1. This equipment complies with Part 68 of FCC rules and
the requirements adopted by the ACTA. On the back of
the equipment is a label that contains, among other
information, a product identifier in the format
US:AAAEQ##TXXXX. If requested, this inf
2. The following USOC jacks may be used with this
equipment: RJ11C.
3. A plug and jack used to connect this equipment to the
premises wiring and telephone network must comply with
the applicable FCC Part 68 rules and requirements
adopted by the ACTA. A compliant telephone cord and
modular plug is provided with this product. It is designed
to be connected to a compatible modular jack that is also
compliant. See installation instructions for details.
4. The REN is used to determine the quantity of devices
which may be connected to the telephone line. Excessive
RENs on the telephone line may result in the devices not
ringing in response to an incoming call. In most, but not
all areas, the sum of the RENs should not exceed five
(5.0). To be certain of the number of devices that may be
connected to the line, as determined by the total RENs,
contact the local telephone company. For products
approved after July 23, 2001, the REN for this product is
part of the product identifier that has the format
US:AAAEQ##TXXXX. The digits represented by ## are
the REN without a decimal point (e.g., 03 is a REN of 0.3).
For earlier products, the REN is separately shown on the
label.
5. If the equipment, MC360 MFP, causes harm to the
telephone network, the telephone company will notify you
in advance that temporary discontinuance of service may
be required. But if advance notice isn’t practical, the
telephone company will notify the customer as soon as
possible. Also, you will be advised of your right to file a
complaint with the FCC if you believe it is necessary.
6. The telephone company may make changes in its
facilities, equipment, operations, or procedures that could
affect the operation of the equipment. If this happens, the
telephone company will provide advance notice in order
for you to make the necessary modifications to maintain
uninterrupted service.
7. If trouble is experienced with this equipment (MC360
MFP), please contact the following for repair and/or
warranty information:
Oki Data Americas, Inc.
2000 Bishops Gate Blvd.
Mount Laurel, N.J. 08054-4620
Telephone:(856) 235-2600 or
(800)-OKIDATA (800-654-3282)
If the equipment is causing harm to the telephone
network, the telephone company may request that you
disconnect the equipment until the problem is resolved.
8. This equipment contains no user serviceable parts. Please
contact Oki Data for service.
9. This equipment cannot be used on public coin service
provided by the telephone company. Connection to Party
Line Service is subject to state tariffs. Contact your state
Public Utility Commission, Public Service Commission, or
Corporate Commission for information.
10.If your home has specially wired alarm equipment
connected to the telephone line, ensure the installation of
this MC360 MFP does not disable your alarm equipment.
If you have questions about what will disable alarm
equipment, consult your telephone company or a qualified
installer.
FCC Telephone Consumer Protection Act
The Telephone Consumer Protection Act of 1991 makes it
unlawful for any person to use a computer or other
electronic device, including FAX machines, to send any
message unless such message clearly contains in a margin
at the top or bottom of each transmitted page or on the first
page of the transmission, the date and time it is sent and an
identification of the business or other entity, or other
individual sending the message, and the telephone number
of the sending machine or such business, other entity, or
individual. (The telehone number provided may not be a 900
number or any other number for which charges exceed local
or long-distance transmission charges.)
To comply with this law, you must enter the following
information in your fax unit:
Product Name
Model Name
MC360 MFP, 120V
N34117A
MC360 MFP, 230V
N34117B
