MB280
- 47 -
Setting up the PC
For this section, refer to the instructions supplied by the
manufacturer of the WLAN USB key to help you to find
and join the "house" network.
1
You may need to install the software for the WLAN
USB key on the PC, if this has not already been
done.
2
Plug WLAN USB key into a USB port on the PC.
3
Use the software of the WLAN USB key to detect
the network.
4
Join the network "
house
" once this has been
detected.
5
Now set up the WLAN network connection of your
PC.
To do this, you must configure the element
Protocol Internet (TCP/IP)
for the WLAN
connection that has been created. If this element is
set up in such a way as to obtain an IP address
automatically, you must change it to manual mode
to set up the TCP/IP address ("169.254.0.1" in our
example), the subnet mask ("255.255.0.0" in our
example) and the default gateway ("0.0.0.0" in our
example).
6
Enter
OK
.
Note
To guide you through this stage, refer
to the paragraph “Setting the
parameters for a connection” in the
manufacturer’s instructions.
