Oki CX4545 MFP, Руководство по копированию

Страница: 15 / 194

1.BEFORE USING EQUIPMENT
Placing Paper 13
1 BEFORE USING EQUIPMENT
 Up to 600 sheets (64 g/m
2
) (17 lb. Bond) can be placed in one drawer. Be sure that the height of the stacked
paper does not exceed the line indicated inside of the side guides.
 P.11 “Acceptable copy paper”
 Fan and jog the stack of paper well before you place it in a drawer, or the sheets may not be separated
before being fed. Be careful not to cut your fingers when fanning.
 Place paper with its copy side up. The copy side may be noted on its wrapping paper.
4
Push the part shown with an arrow (right side) of the
side guide to unlock it.
5
While holding the green lever of the side guide in the
direction of the arrow, set the side guide to the
desired paper size.

The paper size is indicated on the bottom inner surface of the
drawer.

Adjust the side guides with both hands.
6
Place paper in the drawer.
7
Adjust the side guides.
Make sure that a gap (“A” in the figure on the right) of 0.5 mm (0.02")
(1.0 mm (0.04") or less in total)
*1
is left between the paper and the side
guide for plain paper. If the gap is inappropriate, it could cause paper
misfeeding.
*1 For thick paper, the gap must be 0.5 mm (0.02") to 1.0 mm (0.04") (1.0 mm
(0.04") to 2.0 mm (0.08") in total).
A