Operation > 67
Density
: Sets scan density - -3, -2, -1,
0
, +1, +2, +3
Input tray
: Select which paper tray you are using,
Tray 1
, Manual Feeder.
Collate
: Select from ON,
OFF
N-up:
Sets the number of images on a page.
Select from:
1in1
, 2in1, 4in1 (horizontal), 4in1 (vertical).
Edge erase
: This sets the peripheral areas of the
document to block out.
Select from:
0.00 in
, 0.25 in, 0.50 in, 0.75 in, 1.00 in
or
0 mm
, 6 mm, 13 mm, 19 mm, 25 mm
Margin shift - righ
t: This sets the amount to shift the
document image to the
right
.
Select from:
0.00 in
, 0.25 in, 0.50 in, 0.75 in, 1.00 in
NOTE:
N-up can only be changed from 1in1 if paper size is set to A4
or Letter and documents are scanned from the ADF. Collate
always defaults to “OFF”, Reduce/enlarge to “100%”, Edge
erase to “0mm (0.001in)” and Margin shift-Right/Bottom to 0
mm (0.00in).
NOTE:
The setting displayed, mm or inch, depends on the setting in
Admin Setup - System Setup - Unit of Measure in Menu Mode.
If Edge Erase is set to other than "0 mm" or "0.00 in,"
Reduce/Enlarge always defaults to "100%," N-up to "1in1,"
and Margin Shift-Right/Bottom to "0 mm (0.00 in)".
NOTE:
Any parts of the image that do not fit on the paper as a result
of this setting, are not printed. The setting displayed, mm or
inch, depends on the setting in Admin Setup - System Setup
- Unit of Measure in Menu Mode. If Margin Shift-Right is set
to other than "0 mm" or "0.00 in," Edge Erase always defaults
to "0mm (0.00in)" and Reduce/Enlarge can be set only to less
than 100%.
