Adjustments and checks before use
18
5.6
Checking and adjusting the holding plate
1.
Check that the clearance between screws in the rail groove and the holding plate is about
0 to 1 mm.
If there is no clearance, a screw will be caught. If the clearance is too large, a screw pile or
screw jump will occur.
2.
If any adjustment is required, loosen the holding plate attaching screw and move the
plate up or down.
3.
If the holding plate makes contact with the escaper, it will affect the smooth operation
of the escaper movement.
4.
After making an adjustment, check the machine operation.
Holding
plate
Loaded
screw
Escaper
The clearance between screws loaded
in the rail and the holding plate should
be about 0 to 1 mm.
Up/down
adjustment
Holding plate
attaching screw
The holding plate must not make contact
with the escaper.
