OHAUS Frontier FC5714, Руководство по обслуживанию, Страница: 20 / 43

20 SERVICE MENU
• Turn the potentiometer, until the special digit „u“ appears in the service
display.
• By pressing the key rpm/rcf the display „rpm/rcf“ is now activated and you
can setup the respective option with the potentiometer.
• At the end of the run you can now hear the audible sound in the setup
volume whereas 0 is the most quiet setup and 9 the loudest one.
Attention : After all points have been reviewed and/or set up, you have to
press shortly the key start to store all parameters. Otherwise the setups were
all for nothing. If the storage has been successful in the display „rpm/rcf“ the
value of the imbalance sensor and the word „StorE“ are indicated.
2.1.10 Submenu Setup of the signal melody
Here you can setup the melody at the end of the run in case the signal generator is activated.
• Activate the operation menu as described under „Activation of the operation
menu (Part 1)”.
• Turn the potentiometer, until the special digit „G“ appears in the service
display.
• By pressing the key rpm/rcf the display „rpm/rcf“ is now activated and you
can setup the respective option with the potentiometer.
• Now the setup melody will be played by the end of the run, whereas you can
choose between 0 and 9 setups (anyway 10 melodies).
Attention : After all points have been reviewed and/or set up, you have to
press shortly the key start to store all parameters. Otherwise the setups were